Subscribe HERE
Test Protocol
This is a factory ammo test with a full custom rifle in 300 PRC using the components and equipment listed below. The goal is to get a baseline idea of the accuracy potential in this rifle. Testing 5 different skus of factory ammo at 100 yards in 5-shot groups will give me a better idea of what bullets to steer towards and which ones to avoid. Unfortunately, the action screws came loose at some point in the test, which obviously messed up our data. However, the rifle still shot very well considering the loose action screws. A follow up test on this same rifle will more clearly demonstrate how accurate this rifle really is.
Equipment
Rifle: Custom
Chambering: 300 PRC
Action: MAC BROs EVO II Steel
Barrel: 30in McGowen 1:9 twist
Brake: Terminator 5 – Port
Rings: Wheeler 34mm
Trigger: Triggertech Diamond Single Stage Flat Shoe
Chassis: MDT ACC Elite
Scope: Arken EP5 5-25×56
Bipod: MDT CKYE Pod Gen 2 double-pull
Magazine: MDT 300 PRC 5 Round
Protektor Rear Bag
Armageddon Gear Kit Bag
Disclaimer
WARNING: The loads shown are for informational purposes only. They are only safe in the system/platform shown and may not be safe in yours. Consult appropriate load manuals prior to developing your own handloads. Risencitizen.com and its authors, do not assume any responsibility, directly or indirectly for the safety of the readers attempting to follow any instructions or perform any of the tasks shown, or the use or misuse of any information contained herein, on this website.
Components/Ammo
Factory Ammo: 300 PRC in order of firing
Weatherby Select Plus: 205gr Berger Elite Hunter
Hornady Precision Hunter: 212gr ELD-X
Hornady Match: 225gr ELD-M
Berger: 215gr Hybrid Target
Berger: 245gr Elite Hunter
Conclusion
Overall, the rifle still shot really well considering the fact that the action screws were not torqued properly during the test. Further testing will show the rifle’s true capabilities, but that will be one of our following posts/videos.
Disclaimer: These links may lead to or include affiliate links, which I make a commission from at no extra cost to you.
https://www.facebook.com/RisenCitizen
Leave a Reply